Welcome Guest! To enable all features please try to register or login.
Options
View
Go to last post Go to first unread
Annapatten  
#1 Posted : 30 June 2020 16:56:08(UTC)
Rank: Newbie

Posts: 1

Hiya, the engine bracket on my parker 21 is coming loose/ has a crack- any suggestions on how to fix this? Or can you buy a new bracket in once piece? Thank you
Geoff Harwood  
#2 Posted : 01 August 2020 21:53:14(UTC)
Rank: Advanced Member

Posts: 278
Location: Christchurch

The engine mount on my P21/30 Cygnus was made of plywood about 30mm thick. It was beginning to delaminate so I made a copy out of 27mm cast Acrylic. Bolting it back was a bit of a challenge - you really need a very small person with very long arms to get a spanner on the nuts. The port one isn't too bad, you can reach it through the cockpit locker but your arms need to be a foot or so longer to reach the starboard ones. Actually I have a lot of 28mm Acrylic left over from other projects so if you want to do the same I could supply!
Lindsey Moscrop  
#3 Posted : 06 August 2020 20:42:53(UTC)
Rank: Newbie

Posts: 7
Location: Norfolk

Interesting topic on engine mounting for the outboard on the Parker 21!

I replaced the original with a similar piece of marine ply and fitting was a bit of a struggle!

I use a Yamaha 6, previously a Johnson 5 although my Yamaha Malta was once put into service!

Recent discussion locally on two Parker owners has been on reinforcing the mount so that it does not flex, by adding brackets of stainless steel to the floor of the cockpit.

Not certain that I want to ‘improve’ on the original setup but any thoughts would be welcome.

Jim Crick  
#4 Posted : 07 August 2020 14:26:25(UTC)
Rank: Member

Posts: 12

I replaced my bracket with plywood, but I placed two wedge shaped pieces between the outboard pad and the face of the well. This has altered the angle of dangle of the outboard which, even at its lowest tilt setting, was sending a bit of a rooster tail out behind the boat. I like to think that more of the energy is now converted into propulsion, and less into a display fountain.

A previous owner had fabricated a very well engineered stainless steel cap to the o/b pad, which I have retained, although it chips paint off the drive leg!

I backed up the fibreglass behind the bracket bolts, but access is certainly not easy. I can get into the "cave" in the stbd quarter, but getting out again is increasingly challenging.

Users browsing this topic
Guest
Forum Jump  
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.

Notification

Icon
Error